Tandberg Data DPS Expansion Module Disk Pack Specifikace stáhnout pdf (Strana 9)

Unpacking and Cabling DPS Expansion Module

This section provides instructions for unpacking DPS Expansion Module, placing it in a rack,

and cabling it to DPS1000 Series, the network, and a power source.

Note

If you are currently using DPS Expansion Module as external storage and you are

upgrading DPS1000 Series, you must also upgrade the DPS Expansion Module

firmware. See Upgrading DPS Expansion Module on page 41 for more information.

Unpacking DPS Expansion Module

Use the following steps as you unpack DPS Expansion Module from its box:

1. Unpack DPS Expansion Module carefully and retain all packing materials.

2. Inspect DPS Expansion Module and its box contents. If any damage is apparent, contact

Support.

3. Place DPS Expansion Module on a flat, stable work surface.

DPS Expansion Module box contents

The DPS Expansion Module box contains the following items:

• DPS Expansion Module enclosure with 12 drives or six drives and six dummy carriers

• Three (3) sets of two power cords (United States, European, and other)

• RS232 serial cable

•SAS patch cable

•Rail kit

• Eight (8) M5 spring washers (tapped hole rack)

• Eight (8) ATX rack slide washers with square holes (square hole rack)

• Two (2) ATX chassis slides

• Eight (8) ATX rack slide washers with round holes (round hole rack)

• Ten (10) M3 x 4 buttonhead oxide patchlocks (all racks)

• Two (2) ATX chassis latches (all racks)

• Two (2) Screw ATX chassis latches (all racks)

• Eight (8) M5 x 12 CSK Phillips patchlocks (all racks)

• Eight (8) Screws 10-32 UNF special Phillips (tapped hole rack)

• One (1) Hex Allen key driver 2 mm (all racks)

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 67 68

Žádné komentáře

Tandberg Data DPS Expansion Module Disk Pack Specifikace Strana 9