Tandberg Data DPS Expansion Module Disk Pack Specifikace stáhnout pdf (Strana 33)

Configuring DPS Expansion Module | 27

Determining the DPS Expansion Module IP address

You must know the DPS Expansion Module IP address to access the web interface.

To determine the DPS Expansion Module IP address

1. Access DPS Expansion Module through the serial console you connected.

2. Press Ctrl+e to open the console menu.

3. Enter 2 (Diagnostics).

4. Enter 6 (StorView Embedded Module Support).

5. Enter 2 (Enter StorView Embedded Module Menu Mode (Exit with CTRL-W)).

6. Enter 1 (View Network Settings).

The console displays the IP address.

Accessing the DPS Expansion Module web interface

You must access the DPS Expansion Module web interface to create the arrays and logical

drives.

To access the web interface

1. Open a web browser and navigate to the DPS Expansion Module IP address on port 9292.

For example, if the IP address is 10.1.1.5, use http://10.1.1.5:9292.

If you are unsure of the IP address, see Determining the DPS Expansion Module IP

address on page 27.

2. Log in. The default username is admin and the default password is password.

Accessing Help

While relevant tasks are described in this document, Help is also available in the web

interface.

Setting up email notices

You can define up to 10 email addresses for email notification. When an event occurs, DPS

Expansion Module will send email to each address.

Note

Email messages are sent to the email server using port 25. If your email server is not

configured to receive on port 25, email will not function properly.

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 67 68

Žádné komentáře

Tandberg Data DPS Expansion Module Disk Pack Specifikace Strana 33