Tandberg Data DPS Expansion Module Disk Pack Specifikace stáhnout pdf (Strana 16)

10 | Unpacking and Cabling DPS Expansion Module

Mounting DPS Expansion Module in a rack

You must mount the DPS Expansion Module enclosure in a rack. Each DPS Expansion

Module enclosure requires 2U of rack space.

If you have a DPS Expansion Module controller enclosure and one or more DPS Expansion

Module expansion enclosures, be sure to mount the controller enclosure in the rack above the

expansion enclosures for easier cabling.

To mount DPS Expansion Module

1. Place the empty enclosure chassis on a stable work surface.

2. Attach the left and right chassis slides to the enclosure sides using a total of six M3 x 4

button head screws, three on each side. The front portion of the chassis slide has two

tangs that insert into holes on the forward edge of the side panel.

3. Assemble the left and right chassis latches using the chassis latch screws (supplied).

Ensure that the latch is oriented as shown in the following figure, with the spring arm

located against its stop. On the right hand side it is at the top, and on the left side it is at

the bottom.

4. Assemble the rack brackets to the rack posts as follows. The brackets are universal and

will fit either side.

a. Locate the guide pin at the rear of each bracket and insert the pin into a rear rack

post hole. Attach the bracket to the rear rack post using the washers and screws

supplied. The screws should be left loose.

b. Extend the rail to fit between the rack posts.

c. Attach the bracket to the front rack post using the washers and screws supplied. The

screws should be left loose.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 67 68

Žádné komentáře

Tandberg Data DPS Expansion Module Disk Pack Specifikace Strana 16